Should I Reuse It? The Transaxle Gear Alignment Has Been Lost. The Old Cv Drive Axle Has A Locking Style (prevailing Torque) Nut. The Most Likely Problem Is The Outer Cv Drive Axle Boot Has Ruptured, Causing The Grease To Leak Out, Allowing Contamination (water And Dirt) To Enter And Damage The Joint. The Most Likely Cause Is The Drive Train Shifting In The Chassis Due To A Broken Engine Mount Or Hardware, Causing Misalignment Of The Cv Drive Axle And Causing The Inner Joint To Bind Or Hang Up. The Most Likely Cause Is A Defective Or Worn Outer Cv Drive Axle Joint. This Is Typically An Outboard Joint Problem. What's The Best Way To Remove It? The Most Likely Cause Is A Broken Bearing Cage Due To Excessive Torque Load. The Cv Drive Axle Outboard Joint Stub Shaft Is Stuck In The Hub Assembly. Only Shafts That Meet The Specifications For Run Out Are Utilized In The Remanufacturing Of A Cv Drive Axle Assembly. Shafts Are Inspected 100% For Run Out To Prevent Vibrations. Always Discard The Old Nut And Install A New One. No! A Prevailing Torque Lock Nut Should Never Be Reused. Always Use A Torque Wrench And Torque The Nut To Manufacture's Specifications. Never Use An Impact Wrench To Install The Retaining Nut On The Cv Drive Axle. This Can Lead To Axle Separation And Damage To The Inner Joint. What Can I Do? Is It Ok To Use An Impact Hammer To Install The Retaining Nut? Never Allow The Cv Drive Axles To Hang Unsupported. Why? I Removed Both Cv Drive Axles At The Same Time And Now I Am Having Problems Reinstalling Them. What Is Causing This? I Installed A Replacement Cv Drive Axle And Now My Abs Light Is On And Won't Go Out. Are The Cv Drive Axle Shafts Balanced At The Factory? Can I Let The Cv Drive Axles Hang While I Am Working On The Car? I Hear A Grinding Noise From The Front End While Driving And See Grease On The Chassis And Suspension. It Will Damage The Unit And Possibly Do Damage To The Hub Bearing Assembly. Never Strike The Outer Joint Stub Shaft With A Hammer. FAQs: Always Use The Proper Press Type Tool To Remove The Old Stub Shaft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |